Ford Watermota Crossflow 1600 Engine Full Recon Freeman Birchwood Delta Boat

No Reserve, Happy Bidding. Here we have a WaterMota Marine Engine based on a Ford Crossflow 1600cc.Used in a myriad of different boats over the years from Delta, Freeman, Birchwood + Others. This engine has been fully restored by my late father with no expense spared. His plan was to install it into a lake day boat but sadly this never happened. The engine has been rebored to + 20 thou, fitted with New Low Compression Pistons, Brand New Piston Rings etc, the Crank Polished with New Main & Big End Bearings.

The Cylinder Head has been Reconditioned with New Valve Guides, Valves & fitted with Hardened Valve Seats so the Engine will run on Unleaded Fuel.It has a brand new Bowman FM160 manifold (at least £400 to buy), brand new Hella Alternator, fitted with electronic ignition (so no points to get dirty). Brand New Ignition Coil, Brand New Carburettor, New Petrol Pump, New Oil Pump & Oil Filter, New Timing Chain, New Jabsco Raw Water Pump to Circulate Water through the Oil Cooler into the Heat Exchanger & out of the Exhaust. New Engine Water Pump to Circulate Water around the Engine Block & Heat Exchanger, New Starter Motor. The list goes on & on, no expense spared! The Bell Housing is to fit a PRM 150 Hydraulic Gearbox.

The cost in parts alone comes to over £3000.00 I think there could be a couple of Jubilee Clips & one Pipe Connector missing from the Manifold, apart from that it’s possibly as good as new. Complete with its own fabricated engine cradle on wheels to move it around the workshop. This Engine will need to be fully run in for a number of hours before using max RPM. As I said above the Engine will run on Unleaded Fuel. Collection Only!!!!

From near Kendal, Cumbria. Also Advertised Elsewhere, So May End Listing EarlyI have now found a Type 1100 Gearbox with Both Forward & Reverse Drive. The box fits the bell housing but feel a drive gear between the engine & gearbox is missing. I’m not sure if the box is fully functioning or not, but it looks to be in good condition. This will be offered to the winning bidder for a mutually agreed amount should they wish to buy it.On 25-Jun-18 at 21:52:40 BST, seller added the following information: Here are the engine heights (approx measurements) it was tricky on your own with just a spirit level & tape rule!

Rear engine mount 420 mm from top of carb. Measurements from underside of the mounting foot, not including the engine vibration mount.Front engine mount 465mm from top of carb. Measurements from underside of the mounting foot, not including the engine vibration mount.Overall height 650mm from lowest point on the engine sump to the top of the carb.